Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Symptom
Possible Problem
No power.
The power cord is not connected or the PT7031
has not been turned on.
Power switch on the back panel is not turned on.
A safety mechanism powered down the PT7031.
No sound
The volume is set too low.
comes from
the PT7031.
Loose or no cable connections on the PT7031 or
source equipment.
MUTE is on.
No on-screen
Video cable is loose or not connected.
display.
The wrong input is selected on the TV.
No sound when
The DVD audio track is recorded at 96kHz.
playing back
specific DVDs.
Specifications
Power Supply Rating
Power Consumption
Signal-to-Noise Ratio
Dimensions (W x H x D)
Weight
Output Power
Drivers
Digital Inputs
Analog Inputs
Video Output
Frequency response
Specifications are subject to change without notice.
All manuals and user guides at all-guides.com
Solution
Plug the PT7031's AC cord into a suitable AC outlet. Then, turn on the
PT7031 by pushing the on/off switch in the rear of the unit.
Turn it on.
Unplug the PT7031 from the AC outlet briefly and then plug it in again so
it will reset itself.
The "+/–" buttons on the top of the PT7031 remote are the master volume
controls. Press and hold the "+" button to increase the volume.
Check that the cables are correctly and firmly seated on both the PT7031
and the source equipment.
Be sure mute function is not activated.
Check that the video cable is connected and properly seated at both the
PT7031 VIDEO OUTPUT and the TV input.
Select the correct input on the TV, the one that corresponds to where the
VIDEO OUT cable from the PT7031 is connected.
Select 48kHz in the DVD menu or connect and use the analog output from
the DVD player.
120 VAC/60 Hz
25W
(A-weighted) >75dB
40" x 6
18.1 lbs. (8.2 kg)
75 Watts (3 x 25) Continuous Average Power
Three NXT Digital 2" x 8" (50mm x 200mm) Flat Panel Drivers
Two Optical/One Coaxial
Stereo x 3
Composite x 1
70 Hz – 20 kHz +/– 3dB
11
3
⁄
" x 6" (1016mm x 170mm x 152mm)
4
Trademark of New Transducers Limited.
Publicidad
