Troubleshooting; Service Centre; Environmental Concerns - Concept VR1000 Manual Del Usuario

EN
TROUBLE SHOOTING
Problem Possible cause
The vacuum cleaner is not turned on
during charging.
The device does not charge.
The vacuum cleaner and base charging
contacts do not touch.
The vacuum cleaner got stuck on the wires
on the ground or it is tangled in curtains
or blankets.
The device is stuck.
The side brush / main brush is stuck and
the device cannot operate normally.
The cleaning was not finished,
The appliance has detected low battery.
low battery.
The Start button is not on.
The planned cleaning did not
start as planned.
The planned cleaning was cancelled.
There is no water in the water tank.
The water is not flowing out from
the device after the water tank
The outlet hole of the device is blocked.
has been installed.
The device is not turned on.
Low battery.
The device does not operate.
The wheels are lowered down and the cliff
sensors report a fall.
There is an obstacle in front of the device.
The device keeps returning.
The bumper is stuck.
The filter grid is stuck.
The device generates loud noise.
The fan operates at maximum power.
48
Remedy
Turn on the device.
Make sure that the device is fully
touching the charging contacts.
The device automatically switches
to the emergency mode. If the
problem persists, the device
requires help manually.
Clean the brushes of dirt wrapped
around them and restart the
device. If the problem persists,
please contact an authorized

service centre.

Charge the device.
Turn on the appliance.
Reset and set the planned
cleaning.
Refill the water tank.
Clean the outlet hole and water
tank filter.
Turn on the appliance.
Charge the device.
Place the device on the ground.
Contact an authorized service
centre.
Remove the obstacles located in
front of the device.
Gently tap on the bumper and
check whether there are no
foreign objects stuck inside.
Adjust the position of the filter
grid.
We recommend that the users
set Silent mode while they are
at home and Strong mode while
they go out.
VR1000
SERVICE CENTRE
Extensive maintenance or repair, which requires access to internal parts of the product, has to be performed by
a qualified specialist or the service centre.

ENVIRONMENTAL CONCERNS

• Packaging materials and old appliances should be recycled.
• Packaging materials may be disposed of as sorted waste.
• Dispose the plastic bags made of polyethylene (PE) of as sorted waste.
Recycling of the appliance at the end of its lifespan:
This appliance is labelled in accordance with European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste electrical and electronic equipment - WEEE). The symbol
on the product or on its packaging indicates that this product may not be treated as household
waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential
negative consequences for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. The disposal of such material has to be done according
to the recycling regulations. For more detailed information about recycling of this appliance see the
authorized local office or service for household waste disposal or the shop, where you purchased the
appliance.
The product meets all the necessary requirements of the EU directives applicable to the specific product.
Changes in text, design, and technical specifications are subject to change without prior notice and we reserve the right
to change them.
VR1000
EN
49