Cleaning And Maintenance - ARIETE ECO POWER 2791/3 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 25
After using the cleaner
Switch off the appliance using the foot switch (D).
Then unplug the appliance from the mains power and hold down the foot pedal (C) on the appliance
until the power cord is fully rewound.
WARNING: While rewinding the power cord, guide it in the right direction by hand to prevent any
risk of injury to yourself.
Put the appliance away, upright, fitting the attachment storage compartment (Q) to the telescopic
tube (O) and hooking on the narrow suction nozzle (V) and the small suction device with brush (Z);
then hook on the tube (O), with the floor brush (R) fitted in the special compartment in the bottom of
the appliance (Fig. 5).
Carrying the vacuum cleaner
Use the special handle (I) on the top of the appliance to carry it.

CLEANING AND MAINTENANCE

WARNING: Before carrying out any cleaning or maintenance operation, switch off the appliance and
unplug it from the mains power.
The dirt vacuumed up will enter the dust container (A). The air is cleaned by a permanent washable
filter that is located inside the dust container, by a motor protection filter and an air outlet filter located
under the appliance.
WARNING: Never use the vacuum cleaner if any filter is missing or damaged. Any dust cleaned up
will enter the appliance and damage the motor.
WARNING: Clean the filters regularly or in any case, whenever the suction power seems to be
reduced.
Emptying the dust container (A)
The transparent dust container means it is easy to see when it is full and ready to be emptied.
- Press the release button (E) and at the same time, remove the dust container (A) using the rel-
evant handle (F) (Fig. 6).
- Use the two levers at the back to open the relevant hatch (Fig. 7).
- To clean the inside of the container (A), it is possible to remove the washable filter by turning it
anticlockwise and pulling it outwards (Fig. 8).
- Empty the dust container (A) (Fig. 9).
- To refit the filter on the dust container (A), insert it and turn it clockwise. Click the hatch shut.
- Refit the dust container (A) onto the body of the appliance (B) so that it clicks into place.
IMPORTANT: When the dust container becomes full, it is advisable to place a plastic bag over the
top and empty it inside the bag itself to prevent dust and dirt from leaking out.
Cleaning the motor filter
The motor filter and its special covering need to be cleaned on a regular basis.
- Use the two levers and lower the hatch in the back section of the appliance (Fig. 10).
- Remove the filter and clean it under running water (Fig. 11). Leave it to dry thoroughly.
All manuals and user guides at all-guides.com
- 9 -
E N

Publicidad

Tabla de contenido
loading

Tabla de contenido