Charging Up The Battery - Hoberg GT100 Traducción Del Manual De Instrucciones Original

Adjusting the Telescopic Rod (Picture D + E)
The length of the telescopic rod (5) can be varied, which means it can be individually
adjusted to suit your body size.
1. Undo the fi xing (4) by turning it clockwise (towards the
2. Pull the telescopic rod out to the length you want.
3. Twist the fi xing anticlockwise to secure it (towards the

Charging Up the Battery

PLEASE NOTE!
■
Only connect the charger to a plug socket that is properly installed and matches
its technical data. The plug socket must be readily accessible after connection
so that the connection to the mains can quickly be isolated.
■
Only use suitable extension cables whose technical data is the same as that of
the charger.
■
Pull the charger out of the plug socket if an error occurs during charging or
before a thunderstorm.
■
Only ever charge up the battery using the charger that is supplied (WJG-
Y091260500WZ). Do not use the charger that is supplied to charge up any other
devices.
■
Before inserting the battery, check whether the contacts are clean and clean
them if necessary.
It is essential that you charge up the battery fully before you fi rst use the
device in order to achieve the maximum charging capacity.
If the battery is fully discharged during use, it must be fully charged up again
i
before it is next used.
We recommend detaching the telescopic rod (5) from the trimmer unit (11) prior to
charging to prevent the device from accidentally being switched on.
1. Pull the silicone cover off the charging socket (13).
2. First plug the barrel connector of the charger into the charging socket and then
connect the charger to a plug socket. The control lamp on the charger lights up red
during the charging process. When the control lamp lights up green, the battery is
fully charged.
3. First disconnect the charger from the mains power and then disconnect the barrel
connector from the trimmer unit.
symbol).
symbol).
EN
21