Continuous Water Drainage - turbionaire Practical 12 Manual De Instrucciones

NOTE
a. Do not remove the float from the water
tank. The water full sensor will no
longer be able to detect the water level
correctly without the float and water
may leak from the water tank.
b. If the drainage tank is dirty, wash it with
cold or lukewarm water. Do not use
detergent, scouring pads, chemically
treated dust cloths, gasoline, benzene,
thinner, or other solvents, as these can
scratch and damage the tank and cause
water leakage
c. When replacing the drainage tank, press
the tank firmly into place with both hands.
If the tank is not positioned properly, the
"TANK FULL" sensor will be activated, and
the dehumidifier will not operate.

9. CONTINUOUS WATER DRAINAGE

The unit features a continuous drainage port .Using a plastic pipe (with an inner diameter
of 10mm) inserts into drain hole (on intermediate plate), reach out from side of water
tank, install it in place, and arrange the drain pipe.
The water in the drainage tank can be continuously drained out from the continuous port
on the unit.
10