Power Supply - Philips SBCSC368 / 85C Instrucciones De Manejo

Notes
– Both the transmitter and receiver have a
'battery low' indication. If the batteries are
low the red POWER LED starts flashing.
– To conserve batteries, connect the units to
the mains by using the enclosed mains
adapters.
– If batteries are installed and the mains
power adapters are connected, the units
operate on mains power. In the event of a
mains failure, the batteries will take over.
OPERATION (fig. 4)
Transmitter
• Make sure the mains power adapter is
connected correctly, or batteries are
installed.
• Place the transmitter near the baby's bed,
making sure that the microphone is placed
in the best position for picking up baby's
sounds.
IMPORTANT!
Make sure that the transmitter is always out of
reach of the baby; never place the transmitter
inside baby's bed or playpen!
• Switch the transmitter on using the ON/OFF
switch (fig. 1.4) .
– The red POWER LED lights up.
– If sound is picked up by the built-in
microphone, the transmitter starts
transmitting automatically. The transmission
stops when no sound is picked up any
more. During transmission the green
TRANSMIT LED lights up.
• The Babysitter sound level can be adjusted
by turning the SENSITIVITY control (fig. 1.5)
to the desired microphone sensitivity level.
– The higher the sensitivity is set, the earlier
the unit starts transmitting when your baby
makes a sound.
SBC368page 5

3. POWER SUPPLY

IMPORTANT
– Replace batteries inside the transmitter with
original PHILIPS LR6 POWERLIFE batteries
only.
– Battery pack inside the receiver has already
been installed. Have these batteries
replaced only by an official dealer or our
service organisation!
4. OPERATION
Receiver
• Make sure that the mains power adapter is
correctly connected to the recharging base.
– The receiver uses rechargeable battery
power only in the event of a mains failure, or
when the unit is not placed inside the
standing base.
• Place the receiver inside the recharging
base, near to the parent's location.
– If the mains power adapter is connected
correctly, the red CHARGE LED on the
recharging base lights up.
• Switch the receiver on to an acceptable
sound level (fig. 1.2) .
– The red POWER LED lights up.
– If a sound signal is received from the 'baby
unit', it is heard via the built-in speaker.
• Adjust the sound level as required.
Notes
Do not place transmitter and receiver too close
to each other while operating. Otherwise the
units will start resonating (giving a high-pitch
sound).
IMPORTANT!
Before using the Babysitter, check the sound
transmission to ensure that both units function
correctly. After this first check, sound
transmission should be checked on a regular
basis as follows:
• Have an adult softly speak into the
transmitter.
– Sounds transmitted from the baby room
should be heard clearly via the receiver in
another room.
5