Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Input, output and audio controls
2
3
4
5
6
7
1. COOLER
1. COOLER
1. COOLERs: It cools the amplifier. Install in a cool place being careful to not
obstruct the air vents.
2. RCA JACK INPUT: Input of the signal to be amplified. Connect to the radio/
player using high quality shielded RCA cables to prevent unwanted noise.
3. LEVEL: Level control for the signal at the amplifier's input.
4. CROSSOVER:
▪ SUBSONIC FILTER:
This variable control allows you to select the initial
frequency from 5Hz to 40Hz that will be reproduced by the amplifier.
▪ LOW PASS FILTER (L.P.F.):
This variable control allows you to select the final
frequency from 30Hz to 250Hz that will be reproduced by the amplifier.
5. BASS BOOST:
▪ BASS:
Variable control for bass boost from 0dB to +10dB.
▪ FREQ:
Variable control for BASS boost frequency from 30Hz to 70Hz.
6. FLAT KEY: This switch allows you to turn the FLAT mode on or off. Settings
made on the CROSSOVER and BOOST controls will be turned off when
using this mode.
7. OUTPUT CONNECTOR (SPEAKERS): MONO output of amplified signal for
speakers connection. Check the minimum impedance and polarities before
performing the installation.
3
Publicidad
Tabla de contenido
