Important Safeguards; Assembly Instructions - Medela Swing Instrucciones De Uso

IMPORTANT
SAFEGUARDS
This is a single user product. Use by more than one
person may present a health risk and performance
questions, and voids the warranty.
When using electrical products, especially when
children are present, basic safety precautions should always
be followed, including the following:
READ ALL INSTRUCTIONS
DANGER:
To reduce the risk of electrocution:
1. Always unplug electrical products immediately after using.
2. Do not use while bathing.
3. Do not place or store product where it can fall or be pulled into a tub or sink.
4. Do not place in or drop into water or other liquid.
5. Do not reach for a product if it has fallen into water. Unplug immediately.
WARNING:
To reduce the risk of burns, electrocution, fire or injury to persons:
1. A product should never be left unattended when plugged into an electric outlet.
2. Close supervision is necessary when this product is used by, on, or near children or invalids.
3. Use the product only for its intended use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
4. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has
been dropped or damaged, or dropped into water.
5. Keep the cord away from heated surfaces.
6. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is
being administered.
7. Plug the power cord into the Swing breastpump first and then into wall socket.
8. Only use the power cord that comes with the Swing breastpump.
9. This product is a personal care item and should not be shared among mothers.
10. Make sure the voltage of the power cord is compatible with the power source.
11. Never use while sleeping or when drowsy.
12. Wash the appropriate pump kit parts before each use.
13. If the suction feels uncomfortable or painful, decrease the suction level. If this doesn't help, turn
product off and remove from your breast. Consult your healthcare professional.
SAVE THESE INSTRUCTIONS
2
All manuals and user guides at all-guides.com
Assembly Instructions - Swing Breastpump
1. Make sure breastshield and connector are
securely attached.
2. Snap membrane onto valve until membrane
lies completely flat.
Be sure to take apart membrane from valve when
cleaning, and dry completely before reassembling.
3. Push assembled valve & membrane
onto connector.
4. Screw container into connector.
5. Insert one end of tubing into
opening into the pump body.
6. Insert other end of tubing into the port onto
the motor.
3