Installing The Rfid Tag - MSA V-TEC io1 Instrucciones De Uso

US
4.2

Installing the RFID Tag

(1) If needed, remove the clasp bar of the V-TEC io1 RFID tag by using a #2 Phillips screw driver.
NOTE: The two assembly screws are captured and should not be fully removed for disassembly.
(2) Position the main body of the RFID carrier at the center of the base of the D-ring. Ensure the MSA logo is right side up.
The recesses in the mounting arms of the RFID carrier body should line up with the sides of the D-ring.
(3) Hold the main body of the RFID carrier in place and rotate the D-ring and carrier downwards until the back of the carrier
is accessible.
(4) Fit the clasp bar into place. Using a #2 Phillips screwdriver, fasten the clasp bar to the main body of the RFID carrier
with the two captured screws.
The D-ring should be facing upward toward the wearer's head for this step.
Ensure the recesses of the RFID carrier arms fully enclose the sides of the D-ring. Do not over-tighten the screws.
(16) With the peel and stick cable tie mount attached to the end of the USB cable, select
a location near the pillar to affix the peel and stick cable tie mount.
NOTE: This location should be easy for the worker to reach and not allow the
stowed cable to interfere with typical picking actions.
NOTE: Wipe the surface clean of grease, dust, debris, or other surface
contaminants that may affect adherence of the peel and stick cable tie mount.
(17) Peel the paper off the peel and stick cable tie mount and firmly stick it to this area.
(18) Reconnect the PIT electrical system to the battery.
NOTE: Be sure power reaches the power pack by looking for the charging lights on
the pack.
(19) Replace the access panel(s) over the control area.
4 Installation
11