Assembly And Installation; Connecting The Et Sensor - Conergy SmartControl System Manual De Uso

6

Assembly and installation

(1)
(7)
(8)
(9)
Conergy SmartControl System
6.1

Connecting the ET sensor

Shield of the connecting cable
Before it is installed in the building where the Conergy
SmartControl is located, the shielding of the connection
cable must be connected to the building's earthing system.
Top
(2)
(3)
(6)
(10)
Fig. 6-1: Attaching the connecting cable
(1) Connecting screw
(2) Housing
(3) Female insert
(4) Rubber seal
(5) Connector
Operating manual
6 Assembly and installation
(4)
Top
(6) Cable end sleeve
(7) Sealing ring
(8) Flat washer
(9) Screw plug
(10) 4-pole shielded
connecting cable
(5)
35