Conergy SmartControl System Manual De Uso página 38

Suggestion
Conergy SmartControl System
+12_Sens
Fig. 6-2: Connection diagram of the female insert (3)
Note the assignment of the connection cable to the female
connectors. The same assignment must be used to connect
the connection cable to the Conergy SmartControl!
Make a table showing how each strand of the cable is
assigned.
No. Assignment
1 +12_Sens
2 LUM
3 Temp
(earth GND_Sens
symbol)
The bar of the female insert in the housing must remain free.
The connecting screw is then screwed into the bar.
9. Tighten the cable screws.
10. Connect the female insert (3), rubber seal (4) and
connector (5)(see Fig. 6-1, page 35).
11. Push the housing (2) onto the connector (5).
Operating manual
6 Assembly and installation
GND_Sens (signal connection,
not earthing!)
Temp
Strand colour/marking
selected by you
LUM
37