Installation Of The Conergy Smartcontrol And Power Supply Unit - Conergy SmartControl System Manual De Uso

6 Assembly and installation
40
Fig. 6-5: Extracting the female insert
4. Remove the female insert
5. Rotate the female insert.
6. Tighten the screw plug.
7. Insert the connecting screw into the housing.
8. Tighten the connecting screw.
6.3 Installation of the Conergy SmartControl and
power supply unit
The Conergy SmartControl and power supply unit consist of
DIN top-hat rail housings and are designed to be fitted to a
DIN top-hat rail in accordance with DIN EN 50022.
CAUTION
Outdoor installation will damage the devices!
The Conergy SmartControl and power supply unit should not
be installed in the open air without additional protection.
| When using the devices outside of enclosed spaces, install
them in an additional housing.
Operating manual
Conergy SmartControl System