Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NORMAL INSTALLATION STEPS
WARNING: This cooktop is not approved for use with
downdraft systems.
1a
PREPARE THE OPENING IN COUNTERTOP
30" COOKTOP
30"
2
1
/
" or 3
1
/
"
2
2
Measured
down from
countertop
edge.
26
5
/
"
8
2
3
/
"
4
min.
2
1
/
"
4
min.
PREPARE THE OPENING IN COUNTERTOP
1b
36" COOKTOP
36"
1
1
2
/
" or 3
/
"
2
2
Measured
down from
countertop
edge.
32
3
/
"
4
2
3
/
"
4
min.
2
1
/
"
4
min.
21
1
/
"
2
19"
*
Allow 5" clearance under
*
cooktop for gas connection
21
1
/
"
2
19"
*
Allow 5" clearance under
*
cooktop for gas connection
ENGLISH – 2
Foam tape
BEFORE INSTALLING THE COOKTOP IN THE
CUT-OUT OPENING DO THIS:
A roll of foam tape is supplied loose and packed in the
literature package. Install the foam tape around the
perimeter of the flange of the burner box, at a distance
of 1/4" from the edge of the glass. Apply the exposed
adhesive side of the tape against the underside of the
glass surface (see figure below). Remove the protective
film from the underside of the foam tape before
inserting the cooktop into the countertop opening.
Note: This tape seals the underside of the cooktop to
the counter. Do not remove this foam tape. This
tape prevents entry of air for normal gas combustion
and prevents liquids from leaking under the cooktop.
After inserting the cooktop into the countertop opening,
make sure the unit is sitting on the metal flange around
the top of the burner box. Cooktop must not sit on the
glass top. Avoid cutting an oversized hole in the
countertop to prevent glass top from sitting directly on
the countertop.
WALL OUTLET
LOCATION
Recommended area
for 120V grounded
outlet on rear wall.
NOTE: If an outlet is not available,
have one installed by a qualified
electrician.
Protective film
12"
8"
10"
22"
of wall
and unit
of floor
Publicidad
Tabla de contenido
