Storing; Cleaning; Maintenance And Repairs; Troubleshooting - Stihl BGA 45 Manual De Instrucciones

14 Storing

14 Storing
14.1 Storing the Blower
STIHL recommends that you store the blower
with a charge between 40% and 60% (2 LEDs
glow green).
► Switch off the blower and remove the activa‐
tion key.
► Observe the following points when storing the
blower:
– Blower is out of the reach of children.
– Blower is clean and dry.
– Charging cable is in an enclosed space.
– Blower is in a temperature range between
0°C and +50°C.
14.2 Storing the Charging Cable
► Disconnect the plug from the wall outlet.
► Observe the following points when storing the
charging cable:
– Charging cable is out of the reach of chil‐
dren.
– Charging cable is clean and dry.
– Charging cable is in an enclosed space.
– Charging cable is separated from the
blower.
– Charging cable is in a temperature range
between 0°C and +40 °C.

15 Cleaning

15.1 Cleaning the blower
► Switch off the blower and remove the activa‐
tion key.
► Clean blower with a damp cloth.
► Clean vents with a paintbrush.

17 Troubleshooting

17.1 Troubleshooting Blower or Charging Cable
Condition LEDs on blo‐
wer
Blower does not 1 LED flashes
start when swit‐ green.
ched on
3 LEDs glow
red.
3 LEDs flash
red.
Blower cuts out 3 LEDs glow
during operation red.
0458-719-9821-C
► Clean the shield with a paintbrush or soft
brush.
15.2
► Disconnect the plug from the wall outlet.
► Disconnect the charger plug from the charge
socket.
► Clean the charging cable with a damp cloth.

16 Maintenance and Repairs

16.1
The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance inter‐
vals:
Every 12 months
► Have the blower checked by a STIHL servic‐
ing dealer.
16.2
The blower cannot be serviced or repaired by the
user.
► If your blower has a malfunction or is dam‐
aged or requires servicing: Contact your
STIHL servicing dealer.
16.3
The charging cable requires no servicing and
cannot be repaired.
► If the charging cable is defective or damaged:
Replace the charging cable.
Cause
Blower has low
charge.
Blower is too hot.
There is a electrical
malfunction.
Blower is damp.
Blower is too hot.
There is a electrical
malfunction.
Cleaning the charging cable
Maintenance Intervals
Servicing and Repairing the
Blower
Servicing and repairing the
charging cable
Remedy
► Recharge the blower.
► Remove the activation key.
► Allow blower to cool down.
► Remove the activation key.
► Do not use the blower and contact your
STIHL servicing dealer for assistance.
► Allow the blower to dry.
► Remove the activation key.
► Allow blower to cool down.
► Switch off the blower, wait 5 seconds and
then switch on again.
English
25