BUTURE BR600 Manual Del Usuario página 10

Step 2:Connect the red clamp to the positive
terminal(+)of the car battery and connect the
black clamp to the negative(-)of the car
battery. If the indicator light of the smart
clamp is solid green, you can move on to the
next step.
However, if the red indicator light is on:
1. The battery clamp may be connected in
reverse. In this case, you need to disconnect
the battery clamp from the vehicle and the
jump starter.
2. Adjust the clamps for maximum contact
with the battery terminals.
Step3: Start Your Car.
If you failed to start your car, you need to
disconnect the battery clamp from the vehicle
and the jump starter.wait for at least 30
seconds, then try again.
Step 4:
Once your car is started. Remove the battery
clamp from the car-battery and the jump
starter within 30 seconds.
In any of the following situations, the smart clamp turns
protection on:
LED indicator
The red/green led will flash
The green light is always on
The red light is always on
Situations
Ready to work
Work status
1.battery clamp is reversely connected
--check whether the clip is reversely connected
2.the clamp is short-circuited
----check whether two clamps together connect
or connect both cable clamps to the same piece
of metal
EN 07