Parts And Functions; Assembly - Ninebot eKickScooter ZING C8 Manual Del Usuario

2 Parts and Functions

Please familiarize yourself with each part. This manual uses C10 as an example and pictures are for illustration purposes only.
The actual product may vary.
Brake lever
Handlebar
Stem
Quick-release
clamp
Front fender
Indicator
Hub motor
Charging port
Footboard
Kickstand
Ambient light
* for ZING C10 and C20 only.
Power button
Press the button to power on or change riding modes. The Turbo mode is set as default when turned on. Hold for 2s
to power o .
Model Turbo mode
ZING C8 10 mph (16 km/h)
Max. speed ZING C10 11.2 mph (18 km/h)
ZING C20 12.4 mph (20 km/h)
Indicator solid, with 1 beep
Ambient light (for ZING C10 and C20 only) full-color pulsing
Battery indication
The color of the indicator shows the battery level: ＞10% white, ≤10% red.
* When an abnormality occurs, the indicator will flash and an alarm will start beeping.
03
Accessories
Power button
Throttle
Bell
* For ZING C20 only.
Folding clasp
* For ZING C20 only.
Battery charger×1
Folding clamp
* For ZING C20 only.
Safety clamp
* For ZING C20 only.
Buckle
* For ZING C20 only.
3/16" (5 mm)
Rear fender
Allen wrench
Reflector
* For ZING C20 only.
Brake
Cruise mode Safe mode
10 mph (16 km/h) 6.2 mph (10 km/h)
11.2 mph (18 km/h) 6.2 mph (10 km/h)
12.4 mph (20 km/h) 6.2 mph (10 km/h)
blink slowly, with 2 beeps blink fast, with 3 beeps
blue pulsing red pulsing

3 Assembly

ZING C8, ZING C10
Press the quick-release button Flip the quick-release clamp
1 2
and insert the stem into the to the closed position to
front fork. The button will pop secure the stem.
out automatically.
Quick-release
button
ZING C20
Insert the stem to the bottom. Lock the folding clamp
1 2
flip the safety clamp
* Align the positioning groove and the
positioning screw, then slide the
closed position.
screw into the groove.
Positioning groove
Positioning screw
WARNING
Power off the scooter before assembling. The brake cable should not wrap around the stem.
NOTE: If the stem is shaky,
you can adjust the knob to
tighten it.
Tighten the two screws
and
3
a
alternately several times.
to the
b
* Once tightened, attempt to
wiggle the handlebar to
ensure it is safely secured.
b
a
04