Threading The Top Thread; Important - Singer Confidence 7463 Manual De Instrucciones

Tabla de contenido

Publicidad

THREADING THE TOP THREAD

A. Raise the presser foot lifter. Always be sure to raise the
presser foot lifter before threading the top thread. (If the
presser foot lifter is not raised, correct thread tension
cannot be obtained.)
B. Turn the hand wheel toward you until the needle is in its
highest position.
C. Thread the machine with your left hand while firmly
gripping the thread with your right hand in the
following order as illustrated.
* Guide the thread through thread guide (1), and
then pull it into the pre-tension guide (2).
* Pull the thread into the tension discs, passing
the thread to the left of plate (2). Then guide the
thread to the bottom of the groove.
* Do a U-turn around the inside of the tab (3).
* Pass the thread through the thread take-up (4)
from right to left.
* Pull the thread into the inside of the take-up lever
until it reaches the eye of the lever.
* Guide the thread into the thread guide (5).
* Pass the thread through the eye of the needle
(6) from front to back. (See following page for
instructions on operation of the Automatic Needle
Threader.)

IMPORTANT:

To verify that the machine is threaded
properly in the tension discs, do this
simple check:
.) With the presser foot raised, pull
the thread towards the back of the
m a c h i n e . Yo u s h o u l d d e t e c t o n l y
a slight resistance and little or no
deflection of the needle.
.) Now lower the presser foot and again
pull the thread towards the the back
of the machine. This time you should
d e t e c t a c o n s i d e r a b l e a m o u n t o f
resistance and much more deflection
of the needle. If you do not detect the
resistance you have miss-threaded the
machine and need to re-thread it.
8
4
5
6
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Confidence 7465

Tabla de contenido