Stryker Isolibrium 297300000000 Manual Del Usuario página 29

Product serial number:
Completed by:
Date:
C C o o v v e e r r r r e e p p l l a a c c e e m m e e n n t t , , t t o o p p
T T o o o o l l s s r r e e q q u u i i r r e e d d : :
• Zipper pull tool or equivalent
P P r r o o c c e e d d u u r r e e : :
1. Apply the brakes on the P P r r o o C C u u i i t t y y bed frame.
2. Unplug the support surface power/data cable from the bed.
3. Remove the power/data cable from the strain relief bracket.
4. Remove the headboard and footboards.
5. Lower all the siderails.
6. Unsnap the two secure snaps (C) at the foot end corners (Figure 18).
7. Unsnap the four corner retainers (B) (Figure 18).
N N o o t t e e
• On install, reconnect the corner retainers. Place the strap below each D-ring at the foot end corners and snap the
cover.
• The zipper starts on the patient right side near the foot end.
8. Insert a zipper pull tool or equivalent through the hole in the zipper slider to unlock.
9. Use the zipper pull tool or equivalent, to unzip the support surface top cover (A) from the bottom (Figure 18).
10. Remove and discard the top cover.
11. Reverse to install the new cover.
2973-009-005 Rev AD.0
A
F F i i g g u u r r e e 1 1 8 8 – – T T o o p p c c o o v v e e r r
B
C
25 EN