Toparc 600L Manual Del Usuario página 8

Translation of the original instructions
Caution:
• Never look directly into the light or shine the light into another person's eyes when it is illuminated.
• Charge the lamp with the chargers that are provided with product. Plug in the charging adaptor into the unit first,
then plug into the charging source.
• Do not cut, pull, or expose the charging adaptors/power cords to extreme heat.
• Do not disassemble the housing. There is no internal serviceable part.
• Pull by the adaptor plug rather than the cord when disconnecting the charging adaptor.
• This unit contains rechargeable batteries. Although the lamp arrives partially charged from the factory, it MUST be
fully charged before the first use.
• Recharge the unit after each use, or every 6 months to prevent the battery charge from depleting.
• Place the charging adaptor cord so that it does not become entangled or become a safety hazard.
• Do not attempt to charge the product if the charging adaptor or power cable is damaged. Contact the manufacturer
for the replacement.
• Keep the charging adaptor cord and power cable away from sharp corners.
CHARGING AND RECHARGING THE INTERNAL BATTERY
This product has been shipped partially charged. Charge the unit right out of the box and before the first use with the
AC Wall Charger for 10-12 hours. Recharge the unit after each use.
IMPORTANT: The internal battery must be charged after each use and every 6 months, even when the
unit is not in use.
Charging and Recharging using AC Wall Charger (Home Charger)
1. Ensure all the power switches are OFF.
2. Insert the barrel (cylindrical) connector (9) of the AC Wall Charger (7) into the Charging Port (2) of the lamp.
3. Plug the male prongs of the AC Wall Charger (7) to a AC wall outlet. The Battery Charging Status Indicator LED (6)
on the unit will illuminate.
4. Recharge the unit until the Full Charge Status LED (6) illuminates GREEN.
Charging and Recharging using 12 Volt DC Charging Adaptor (Car Charger)
1. Ensure all the power switches are OFF.
2. Insert the barrel (cylindrical) connector (9) of the 12 Volt DC Car Charger (8) into the Charging Port (2) of the
lamp.
3. Insert the 12 Volt DC plug into the 12 Volt DC power source. The Battery Charging Status Indicator LED (6) on the
unit will illuminate.
4. Recharge the unit until the Full Charge Status LED (6) illuminates GREEN.
IMPORTANT: Some vehicles require the ignition to be turned ON in order to power up the cigarette ligh-
ter socket, or the accessory outlet.
Notice: When the lamp is under charged, the light will NOT function and it will be immediately turned
OFF upon connecting to the AC or DC charger.
OPERATING INSTRUCTIONS
Worklight - High and Low beam intensity:
Press the Power ON/OFF Button (1) once, the LOW BEAM INTENSITY mode with 120 LEDs will illuminate.
Press the Power ON/OFF Button (1) twice, the HIGH BEAM INTENSITY mode will illuminate.
Press the Power ON/OFF Button (1) three times, the WORKLIGHT will turn OFF..
8
UNDER BONNET LAMP 600L
2 1
2
1 6
EN