Safety Warnings; Introduction To The Product; Preliminary Checks - Key Automation SEL1 Instrucciones Y Advertencias Para Su Instalación Y Uso

1 - SAFETY WARNINGS

WARNING - for the safety of people, it is important to observe these instructions and keep
them for future use.
Read the instructions carefully before installation. The design and manufacture of the devices which
make up the product and the information contained in this manual comply with the current safety
standards in force. However, incorrect installation and programming can cause damage to property
and injury to persons who carry out the work and those who use the system. It is, therefore, important
to carefully follow all the instructions given in this manual during installation.

2 - INTRODUCTION TO THE PRODUCT

LEVANTE DIGITAL SELECTOR FOR AUTOMATIC DOORS
SEL1 and SEL2 Digital Selectors are automatic door control devices. Communication with the CTLEV
control unit takes place via the Bus interface.
When switched on, the Selector will test all the LEDs present, after which the LED corresponding to
the status of the automatic door will light up. If there is an error condition, the red LED with the warning
symbol will light up, while if the door battery is low, the red LED with the battery symbol will light up.

3 - PRELIMINARY CHECKS

WARNING - before installing the product, verify and check the following points:
• Check that the surface on which the device will be fixed is solid and does not vibrate
• Use suitable electrical connections for the current required
• Check that the power supply complies with the values of the technical specifications
• Disconnect the power supply before installing
• Make sure there is a circuit breaker in the power supply system with a distance between the contacts
that allows for total disconnection under the conditions laid down by overvoltage category III
4 - PROGRAMMING
4.1 DIGITAL SELECTOR LAYOUT
There are 8 blue LEDs that indicate the status of the automatic door, 2 red LEDs that report errors and a
button to select the statuses and possibly to reset the CTLEV card. The SEL2 selector is also equipped
with a safety key unlock feature.
BUTTON
RED
LED
INTERNAL
BLUE
RADAR
LED
OPENING
UNLOCK
KEY
PHARMACY
EXTERNAL
BIDIRECTIONAL
RADAR
PARTIAL LOCKED
DELAYED
FREE
BLOCK
EN
+