Publicidad
Idiomas disponibles
Idiomas disponibles
Return Information
•
A return merchant authorization number must be obtained from your local M-Audio representative. For your representative
go to m-audio.com.
•
A copy of the original sales receipt must also be included for the equipment to be repaired under warranty.
•
The faulty equipment must be packed in its original packaging.
•
One additional outer layer of packaging must be included to ensure product safety. Failure to do so may inadequately
protect the equipment in transit and therefore jeopardize the warranty.
•
M-Audio will not accept COD shipments and no call tags will be issued for merchandise return.
•
M-Audio will not return repaired merchandise to customers by priority service except by written request at the customer's
cost. Requests must be submitted in writing with returned merchandise.
•
The defective M-Audio equipment should be sent freight prepaid with the return merchant authorization number printed
clearly on the outer packaging and original sales receipt enclosed to your local service center.
Very Important
Please read this section before connecting this unit to your system:
For optimum performance:
•
All slide faders are subject to wear. Excessive force can wear out the faders quickly. User-replaceable slide faders are not
covered by our warranty.
•
Never use spray cleaners on the slide controls. Residues cause excessive dirt build-up and this will void your warranty. In
normal use, slide controls can last for many years. If they malfunction (usually because of a dirty or dusty environment),
consult a professional technician.
•
Always make sure that AC power is off while making any connections.
•
Use appropriate cables throughout your system. Do not use excessively long cables (i.e. over 32 feet / 10 meters). Be sure
plugs and jacks are tightly mated. Loose connections can cause hum, noise, or intermittents that could easily damage
your speakers. Make the input and output connections with readily available low-capacitance stereo cables. Cable quality
makes a big difference in audio fidelity and "punch." See your M-Audio dealer or an electronics or audio specialist store if
you are not sure which cables to use.
•
Never attempt to make any adjustments other than those described in this manual, or repairs. Take the unit to your dealer
or to an authorized M-Audio service center.
•
Always remember: turn amps on last and off first. Begin with master faders or volume controls on minimum and the
amplifier gain/input control(s) down. Wait 8–10 seconds before turning up the volume. This prevents transients which may
cause severe speaker damage.
•
Use restraint when operating controls. Try to move them slowly. Rapid adjustments could damage equipment due to
amplifier clipping.
•
Avoid amplifier "clipping" at all costs: this occurs when the red LEDs (usually on the front panel of most professional
power amplifiers) start flashing. "Clipping" is when the power amplifier is distorting and working beyond its limits.
Amplifier distortion is the main cause of speaker failure.
•
To prevent fire or shock hazard, do not expose the unit to rain or moisture. Never place cans of beer, soda, glasses of
water or anything wet near or on top of the unit!
•
Headphone outputs can be set to levels which can cause damage to your ears. Use caution.
•
This unit may contain a microcomputer for signal processing and control functions. In very rare situations, severe
interference, noise from an external source, or static electricity may cause it to lock up. In the unlikely event that this
should happen, turn off the unit, wait at least five seconds, and then turn it back on again.
•
Under rare circumstances, if this product is exposed to electromagnetic interference during use, there may be a slight
drop in signal-to-noise ratio.
•
Intended electromagnetic environments: residential, commercial, light industrial, urban outdoors.
Important Safety Instructions
1. Read and keep these instructions. Heed all warnings and follow all Instructions.
2. Do not use this apparatus near water (if applicable).
3. Clean only with dry cloth.
4. Do not block any ventilation openings (if applicable). Install in accordance with the manufacturer's instructions. Do not
install this equipment in a confined or "boxed-in" space such as a bookcase or similar unit, and maintain good ventilation
conditions. The ventilation should not be impeded by covering the ventilation openings with items such as newspaper,
tablecloths, curtains, etc.
5. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that
produce heat. Do not place exposed flame sources such as lighted candles on the apparatus.
6. Do not defeat the safety purpose of the polarized or grounding-type plug (if applicable). A polarized plug has two blades
with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the
third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
7. (If applicable) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and
the point where they exit from the apparatus.
8. Only use attachment/accessories specified by the manufacturer.
9. Use only the cart, stand, tripod, bracket or table specified by the manufacturer, or sold with the apparatus
(if applicable). When a cart is used, use caution when moving the cart/apparatus combination to avoid
injury from tip-over.
10. Unplug this apparatus during lightning storms or when unused for long periods of time.
11. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
5
Publicidad
