Publicidad
Idiomas disponibles
Idiomas disponibles
9. Press Enter to start auto tuning
10.
You can watch TV programs when auto tuning is finished
Basic Operation
Turning on and off the TV
Turn on the TV
●
Connect the power cord to mains,and the TV will enter standby mode.
Press the POWER button on remote control to turn on TV from standby mode.
Turn off the TV
●
To enter standby mode, Press the POWER button again on remote control.
Do not leave your TV in standby mode for long periods of time.It is best to unplug the TV from the mains and antenna.
No signal
●
No Signal Menu will be displayed on screen when there is no input signal. If there is no signal in five minutes in TV/DTV
mode ,the TV will turn off automatically. The TV will automatically turn off in 16 seconds in case of no input signal in PC-RGB
mode.When VGA cable is connected, the TV turns on automatically.
Program Selection
Using CH+/CH- on the panel of TV or on the remote control.
●
Press CH+ to increase channel number.
Press CH- to decrease channel number.
Using 0-9 digital button.
●
You can select the channel number by pressinng 0 to 9 in TV/DTV mode.
Example
●
To select-channel(e.g.channel 5):Press 5.
To select-channel(e.g.channel 20):Press 2 and 0 in a short time.
Volume Adjustment
● Press VOL+/- button to adjust the volume.
● If you want to mute the sound ,press
.
● You can release mute by pressing
or increasing/decreasing the volume.
All manuals and user guides at all-guides.com
Changing the input source
You can select input source by pressing SOURCE button on remote control. Press
and press ENTER button to confirm your choice.
:
NOTE
The picture is just for reference.please operate with the OSD MENU of concrete TV and refer to the AV terminal board.
●
Menu Operation
How to Navigate through Menus
Before using the TV follow below steps to learn how to navigate through menus in order to select and adjust different functions.The
access step may differ depending on the selected menu.
1.Press MENU button to display the main menu.
2.Press
/
button to cycle through main menu.
3.Press Enter to skip to sub menu.
4.Press the
/
button to select the desired sub item.
5.Press the ENTER button to access the submenu.
6.Press
/
button to select the desired value.The adjustment in the OSD may differ depending on the selected menu.
7.Press MENU button to return to the previous menu.
8.Press EXIT button exit from the menu.
NOTE:
● When an item in MENU is displayed gray,it means that the item is not available or cannot be adjusted.
● Button on the TV have the same function as corresponding button on the remote control.lf your remote control is lost or couldn't work,you
may use the button on the TV to select menus.This manual focuses on operation of the remote control.
Picture Menu
Picture Mode
●
Picture Mode provides five pre-defined image settings: Standard, Optimal,Vivid,Mild and User
Contrast, Brightness, Sharpness and Tint (NTSC) can be adjusted when the Picture Mode is set to User.
/
button to choose your preferred source
Publicidad
