Swash Installation - brondell SWASH CL950-EW Manual Del Usuario

All manuals and user guides at all-guides.com
PRODUCT INSTALLATION

Swash Installation

Please read these instructions carefully before installing the Swash.
Failure to do so could result in flooding, leaking or damage to the product.
NOTE: Steps may vary by type of seat and toilet
1. Existing Toilet Seat Removal
a. Lift hinge covers and use a screwdriver to remove the
mounting bolts.
b. Remove the toilet seat. Keep for future use.
2. Turn Off Water Supply Valve and Flush Toilet
a. Turn water valve off to stop the flow of water.
b. Flush toilet and hold down handle to completely empty tank.
c. Disconnect water supply hose from toilet tank. Do not
disconnect from the water supply valve.
NOTES
• You may wish to place a container under the tank to catch excess water.
• Do not continue without completing the above steps
• Failure to do so could result in flooding, leaking or damage to the Swash.
3. Connect the female side of the T-Valve to the incoming water
connection on the bottom of your toilet tank, ensuring the rubber
washer is properly seated.
NOTES
• The T-Valve connects to the fill valve directly under your toilet tank - it
does not connect at the wall.
• Only connect to the cold toilet water supply line.
• If your water supply line is rigid you may need to replace the water
supply line before continuing.
4. Connect the water supply line coming from the wall to the bottom of
the T-Valve
5. Install Mounting Plate for Standard Installation (see page 12, step 6
for instructions on using the Top-Mount Brackets)
a. Place adjustable mounting plate over mounting holes on toilet,
rubber side facing down, arrow pointing to the toilet bowl.
b. Insert the mounting bolts through the mounting plate and
mounting holes of the toilet. Be sure that the square mounting
bolt head is even with the sides of the mounting plate.
Step 2c
Toilet tank
T-valve
Cold
water
supply
line
Steps 3-4
Steps 5b & 5c
11