Eldom slab HC500C Instrucciones De Uso página 15

• It is forbidden to use the heater where hanging objects can easily fall.
• It is forbidden to use the heater in an unstable or shock-prone location.
• If the heater is wall-mounted, make sure that the fixing is secure and there is no danger
of the heater being torn off the wall.
• Do not use the heater around a pool.
• When using the heater, the power cord must be placed in the back of the body, placing
it in front of the body will cause overheating or damage, and could be dangerous.
• Do not connect other high power electrical appliances to the same outlet.
INSTALLATION
Before starting the assembly, make sure the appliance is switched off and disconnected
from the power source.
Installing the feet with castor wheels (Fig. 2)
• Turn the heater body upside down, remove the screws and feet supplied with the unit.
• Align the screw holes in the feet with the mounting holes on the bottom of the rear
housing, then insert the screws through the round holes in the feet and tighten the
them.
• After completing the assembly, turn the body over and place the unit on a flat, stable
and heat-resistant surface, and connect it to the power source.
Wall mounting (Fig. 3)
CAUTION. The heater must be installed at least 15 cm from the floor and 50 cm from
the ceiling.Before drilling, make sure that there are no hidden electrical wires or pipe
in the drilling area.
Drill two holes, 8 mm diameter and 40 mm depth, as shown in figure 3.
•
• Insert the supplied rawl plugs into the holes and then screw in the screws - the screws
must protrude by 6 mm from the wall, finally hang the product using the hook holes at
the back.
• Connect to the power supply.
Fig. 2 Fig. 3
420
275
15