Conformity And Approval Of The Microphone; Power Supply - Monacor JTS MH-850/1 Manual De Instrucciones

3 Applications
In combination with the receiver US-8001D / 1
(1 receiver unit) or US-8002D / 1 (2 receiver units)
from JTS, this dynamic hand-held microphone with
integrated UHF PLL transmitter makes up a wireless
audio transmission system The transmission chan-
nel can be selected as desired from 16 channels in
the UHF frequency range of 863 to 865 MHz

3.1 Conformity and approval of the microphone

Herewith, MONACOR INTERNATIONAL declare that
the wireless microphone MH-850 / 1 complies with
the directive 2014 / 53 / EU The EU declaration of
conformity is available on the Internet:
www jts-europe com
The wireless microphone is licence- free and
generally approved for operation in EU and EFTA
countries

4 Power Supply

•
Only insert batteries of the same type and always
replace all batteries
•
If the microphone is not used for a longer period,
remove the batteries Thus, the microphone will
not be damaged in case of battery leakage
1) Unscrew the microphone cartridge (1)
2) To unlock the battery holder (7), push the lock
(6) to the rear in arrow direction
3) Pull out the battery holder to the stop (fig 4)
and insert two 1 5 V batteries of size AA (R6)
with the positive and negative poles as indicated
on the holder
4) Push back the battery holder until it engages
5) Place the microphone cartridge on the handle
in such a way that the 4-pole contacts (5) of the
cartridge and of the handle fit into each other,
then screw the cartridge on the handle
Never put discharged batteries or defective
rechargeable batteries in the household
waste To protect the environment, always
take them to a special waste disposal, e g
collection container at your retailer
5 Operation
1) Before switching on the microphone, set the
receiver to an interference-free transmission
channel (see instruction manual of the receiver)
2) Then switch on the microphone: Set the sliding
switch (4) to ON The LED status indicator (3)
shows green to indicate normal operation If it
shows red after switching on or during operation,
the inserted batteries are almost discharged and
must be replaced
3) To adjust the transmission channel, remove the
plastic cap (2) For this purpose, slightly press
the grooved latch on the side of the cap, then
remove the cap
4) Set the microphone to the same channel adjusted
on the receiver: Turn the rotary switch CH (8) by
means of the small adjusting key supplied in such
a way that the arrow will point to the desired
channel The 16 transmission channels are as-
signed to the following transmission frequencies:
Channel Frequency
1 863 125 MHz
2 863 250 MHz
3 863 375 MHz
4 863 500 MHz
5 863 625 MHz
6 863 750 MHz
7 863 875 MHz
8 864 000 MHz
Note: If other wireless transmission systems are operated
with this wireless system at the same time, the radio
frequencies of the individual systems should be carefully
matched to each other to prevent interference
5) After adjusting the transmission channel, replace
the plastic cap
6) To switch off the microphone after operation, set
the sliding switch (4) to OFF
6 Specifications
Type of unit: � � � � � � � � � � dynamic hand-held microphone
Polar pattern: � � � � � � � � � hypercardioid
Radio frequency range: � � 863 – 865 MHz, divided into
Audio frequency range: � � 50 – 16 000 Hz
Frequency stability: � � � � � ±0�005 %
Transmitting power: � � � � � 10 mW (EIRP)
Ambient temperature: � � � 0 – 40 °C
Power supply: � � � � � � � � � two 1�5 V batteries
Dimensions: � � � � � � � � � � ⌀ 55 mm × 260 mm
Weight: � � � � � � � � � � � � � � 250 g
Subject to technical modification
All rights reserved by MONACOR
Co. KG. No part of this instruction manual may be reproduced
in any form or by any means for any commercial use.
Channel Frequency
9 864 125 MHz
10 864 250 MHz
11 864 375 MHz
12 864 500 MHz
13 864 625 MHz
14 864 750 MHz
15 864 875 MHz
16 865 000 MHz
with PLL multifrequency trans-
mitter
16 channels ( table)
of size AA (R6)
INTERNATIONAL GmbH &
®
7