Section 3: Assembly; Attach Handle; Add Engine Oil And Fuel; Connect Hose And Water Supply To Pump - Briggs & Stratton PRO3400 Instrucciones De Uso

Ocultar thumbs Ver también para PRO3400:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 3: Assembly

Attach Handle

1.
Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports (Figure 2).
Figure 2 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriage bolts through holes from outside of unit
and attach plastic knob from inside of unit (Figure 3).
Tighten by hand.
Figure 3 — Secure Handle
3.
Insert multi–colored spray tips in spaces provided in
handle.
Handle
Handle
Supports

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine operaor's manual for oil and fuel fill
information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
Connect Hose and Water Supply to
Pump
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1.
Uncoil high pressure hose and attach quick connect
end of hose to base of spray gun (Figure 4). Pull down
on collar of quick connect, slide onto spray gun and let
go of collar.Tug on hose to be sure of a tight
connection.
8

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

01988-1

Tabla de contenido