Gira 5437 00 Manual De Instrucciones página 9

Actuador inalámbrico de persianas de 1 elemento
Invert movement direction
Behaviour on voltage return
Configured venetian blind po-
sition
Configured slat position
Behaviour after the end of the
disabling function
Manual saving of the scene
values
Priority, lock-out protection
Activate lock-out protection
blind position
Activate lock-out protection
slat position
Deactivate lock-out protection
blind position
Deacitvate lock-out protection
slat position
32581822 10864990
On, Off
Basic setting: Off
No change
Configured value
Basic setting: No change
0 ... 100 %
Basic setting: 0 %
0 ... 100 %
Basic setting: 0 %
no change
Last value
Down
up
Basic setting: No change
On, Off
Basic setting: On
0...4
Basic setting: 1
0 ... 100 %
Basic setting: 0 %
0 ... 100 %
Basic setting: 0 %
0 ... 100 %
Basic setting: 0 %
0 ... 100 %
Basic setting: 0 %
23.03.2017
Inverts the activation of the re-
lay outputs. During inverted
operation, the relay outputs
"Up" and "Down" should be
activated in reverse. This is re-
quired, for example, for con-
trolling skylights.
Defines the behaviour of the
output after voltage return.
RMD design: Bus voltage re-
turn
If the value "Configured posi-
tion" is entered for the para-
meter "Behaviour after voltage
return", then the blind/shutter
position set here is approa-
ched.
If the value "Configured posi-
tion" is entered for the para-
meter "Behaviour after voltage
return", then the slat position
set here is approached.
Behaviour of the output when
a block is removed.
Disables the saving of the cu-
rrent Venetian blind position
as scene value in an actuator
for a command via a transmit-
ter.
Specifies the priority for reca-
lling and removing a scene of
type Lock-out protection for
the channel.
Defines the behaviour of the
output on activating the lock-
out protection.
Defines the slat position of the
output on activating the lock-
out protection. Only visible
when the Venetian blind ope-
rating mode is set.
Defines the behaviour of the
output on deactivating the
lock-out protection. Only visi-
ble when the priority for the
lock-out protection is 0.
Defines the behaviour of the
output on deactivating the
lock-out protection. Only visi-
ble when the priority for lock-
out protection is 0 and the Ve-
netian blind operating mode is
set.
9/12