Overview Of The Components - BOMANN HL 6041 CB Manual De Instrucciones

• Do not use the fan heater in the open air.
• Do not use the fan heater in close proximity to bathtubs, showers
or swimming pools.
• The fan heater should not be placed directly below a mains power
socket.
• Do not repair the appliance by yourself. Always contact an au-
thorized technician. If the supply cord is damaged, it must be re-
placed by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Unpacking the Appliance
1. Remove the appliance from its packaging.
2. Remove all packaging material such as foils, padding,
cable holders and cardboard.
3. Fully unwind the cable.
NOTE:
There might be dust and production residue present on
the appliance. We recommend cleaning the appliance as
described under "Cleaning".

Overview of the Components

1 Temperature control
2 Handle
3 Function control knob
0 = Off
I = 1000 Watt
I I = 2000 Watt
= Fan
4 On / off switch oscillation
5 Foot
6 Safety switch
7 Grille for heating elements
8 Indicator lamp
Notes for Use
Electric Connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Set the control knob to 0.
3. Connect the mains plug to a properly installed isolated
ground socket.
32
HL6041CB_IM
Connected Load
The appliance supports a power input of 2000 W.
CAUTION: Overload
• When using an extension cord, it must have a cable
cross-section of at least 1.5 mm².
• Do not use multi-outlet power strips, since this appli-
ance is too powerful.
• Do not connect any other powerful appliances to the
same electric circuit.
Safety Switch
Your fan heater features a safety switch that disconnects
the power supply in case the appliance falls over. The safety
switch prevents hazards caused by overheating.
WARNING:
Place the appliance on a smooth, horizontal surface. Avoid
carpets in order to prevent failure of the safety switch.
NOTE:
The appliance turns on automatically once back in an
upright position.
Operation
Setting the Temperature
The thermostat constantly switches the fan heater on and
off, thereby keeping the temperature at the desired level.
Set the desired temperature as followed:
1. Set the temperature control to its highest setting.
2. Once the desired temperature has been reached, slowly
turn the temperature control back, until the fan heater
switches off audibly. The indicator lamp turns off.
NOTE:
The audible position of the temperature control de-
pends on the ambient temperature.
05.05.20