Troubleshooting - Briggs & Stratton SNAPPER XD 20SPWM48 Manual Del Propietário

Podadora de césped de 20 pulgadas inalámbrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

PROBLEM
The mower does
not start.
The mower
cuts the grass
unevenly.
The mower
does not mulch
properly.
The mower is
hard to push.
The mower is
excessively noisy
and vibrates.
POSSIBLE CAUSE SOLUTION
The battery is not
charged.
The switch is defective.
Grass jammed between
the deck and blade.
The battery is not fully
inserted in the mower.
Battery may require
service or replacement.
The lawn is rough or
uneven.
The cutting height is not
set properly.
Wet grass clippings are
sticking to the underside
of the deck.
The mulching plug is
missing.
The grass is too tall, or
the cutting height is too
low.
The rear of the grass
catcher bag is dragging
in thick grass.
The motor shaft is bent.
The blade is unbalanced.
Charge the battery.
Replace the switch (Contact an
authorized service center ) .
Remove battery; check under
deck for jams.
Check the connection between
the battery and the mower. Make
sure the battery clicks into place.
Contact an authorized service
center or replace battery.
Check the mowing area.
Move the wheels to a higher
setting.
Wait until the grass dries before
mowing.
Install the mulching plug.
Raise the cutting height.
Empty the grass clippings from
the grass catcher bag.
Stop the motor, and inspect for
damage.
Repair before restarting. If
vibration persists, contact an
authorized service center.
30

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Snapper xd 20spwm48kSnapper xd 1688022

Tabla de contenido