Cleaning And Care - Unold 48845 Instrucciones De Uso

ches off and a signal beeps ten
times. The display shows 0:00.
19. If the ice cream is not removed
within 10 minutes after the "fini-
shed" signal, the automatic coo-
ling function switches on to pre-
vent the ice cream from melting.
20. The automatic cooling function
keeps the ice cream cold for a
maximum of one hour.
Remove ice cream
21. Before removing the ice cream
from the appliance, switch off the
appliance with the POWER switch
and unplug the power cord from
the electrical outlet.
22. Remove the transparent lid.
23. Remove the ice cream container
from the appliance and carefully
pull the mixer out of the contai-
ner.
24. Transfer the ice cream to a suita-
ble container. Do not use sharp or
pointed objects for this; instead,
use a plastic or wooden spoon in

CLEANING AND CARE

Before cleaning, always turn
off the appliance, unplug it
from the electrical outlet and
allow the appliance to cool.
1. Never clean the appliance with or
under water or other liquids. It is
especially important to keep the
motor and the compressor from
coming into contact with water.
2. Do not use harsh or abrasive clea-
ners.
order not to damage the ice cream
container. We recommend using a
silicone dough scraper.
25. If desired, you can make more ice
cream right away. In this case,
start again with step number 1.
26. Tip: If you make fruit ice cream
or sorbet, remove the ice cream
container as soon as the program
is finished, transfer the ice cream
to a container suitable for freezing
and put this container in the free-
zer so that the ice cream freezes
completely. Otherwise, this ice
cream may be slightly soft inside,
even if it is firmly frozen on the
outside.
27. If you do not wish to make more
ice cream, switch the appliance
off with the POWER switch and
unplug it from the electrical out-
let.
3. The removable parts can be clea-
ned in warm water with mild dish-
washing detergent. These parts
are not dishwasher-safe. Do not
immerse the container in water.
4. Wipe off the compressor housing
with a damp cloth.
5. Dry all parts thoroughly with a soft
cloth before reassembly.
29