Rear Panel; Connecting Speakers - Work Pro PA 200 MX Manual De Uso

EN

REAR PANEL

AC IN connector
12.
Connect the supplied power cord.
Caution
·When connecting the power cord, connect the power cord to the connector and then plug
it into an appropriate AC power outlet.
·Before connecting or disconnecting the power cord, make sure that the power to the
device is turned off.
[SPEAKERS] output terminals
13.
Barrier strip type speaker output connectors. Refer to "Connecting Speakers" for
the installation instructions.
[SETUP]
14.
Allows to set some functions (Check DIPSWITCHES FUNCTIONALITY section)
15. [OUTPUT]
Sets the output type of amplifier: high-impedance connection ([100V], [70V]) or
low-impedance connection ([8Ω 16Ω]).
16. [RS485 input (RJ45 connection)]
It is possible to send RS485 commands from an external device in order to control
several function in the amplifier .
17. [LINE OUT]
RCA type stereo output jack (unbalanced output). Allows to send preamplified signal
to another amplifier.
[INPUT 2 & 3]
18.
These stereo RCA connectors (unbalanced) correspond to INPUT 2 & 3. They accept LINE level
19.
[MIC INPUT SIGNAL]
Terminal block that accepts microphone input level.
[MIC LEVEL]
20.
Adjusts the MIC input volume. Turning to the right increases the level.
[BT ANTENNA]
21.
Bluetooth antenna

CONNECTING SPEAKERS

Change the setting depending on the speaker connection (high- or low-impedance
connection).
CAUTION
·Before connecting speakers, make sure that the power of the device is turned off.
If the power is on, there is a risk of electrical shock.
·In a high-impedance installation, make sure that the sum of the power input
ratings of the speakers to be connected does not exceed 200W.
·In a low-impedance installation, make sure that the total impedance of speakers
to be connected is at least 8 ohms.
12 21
SPEAKERS
DIP switches
switch
knob
4
13 16
17
L
R
SETUP DCP
15
14
User Manual / Manual de uso
18
19
G
L L
R R
20
PA 200 MX