End Of Operation; Precautions - Omnitronic CDP-360 Manual Del Usuario

Possibility 1:
The player is in Playback-mode.
If the loop-button is pressed in the playback-mode, the CD keeps running and the A-point (starting-point) is
marked (Loop-LED flashes). If the Loop-button is pressed once more, the B-point (end-point) of the
sequence is marked (Loop-LED shines permanently).
The player repeats the sequence between A-point and B-point until you press the Loop-button once more
(Loop-LED off).
Possibility 2:
The player is in Playback-mode.
Press the Play/Pause-button and the player goes into Pause-mode.
Select the A-point (starting-point) via the Jog/Shuttle-wheel. The display shows the selected A-point (e.g.
3:42 22). Press the Loop-button and the selected A-point is marked (Loop-LED flashes).
Select the B-point (end-point) via the Jog/Shuttle-wheel. The display shows the selected B-point (e.g. 3:51
11). Press the Loop-button and the selected B-point is marked (Loop-LED shines permanently).
The player repeats the sequence between A-point and B-point until you press the Loop-button once more
(Loop-LED off).

6.10 End of operation

Before you switch off the device, please make sure that no CD remains in the player.
Also make sure that the CD-tray is completely closed before you switch off. If this is not the case, switch the
device on again and close the tray with the Open/Close-button.

7. PRECAUTIONS

This CD player cannot be compared to conventional Hifi CD players - even if they have almost the same
appearance. This player is much more rugged in order to withstand the strenous road use and consistent
transports of mobile discotheques. We recommend to put the CD player on plastic foam or on rubber feet in
order to avoid Trackping, which is caused by vibrations of low frequencies. The same thing holds true if the
CD player is mounted in a rack an the rack is exposed to such frequencies.
Should you have further problems, please refer to the chart below.
The adjustments of the Pitchfader change the FM frequencies. Should the display repeatedly show "ERR"
adjust the frequencies.
Have the connections correctly been carried out?
Is your amplifier and your mixer properly adjusted?
Have you kept to all instructions given in this manual?
SYMPTOMS
Device does not react when swit-
ching on.
Player does not start operation
No sound
Does not read properly.
Does not read the program
Pop noise
POSSIBLE CAUSES
Connection to mains disrupted.
CD is badly positioned or dirty
Check the mixer and amplifier
connections
The device is exposed
vibrations.
The player is in normal playback
mode
Mixer or amplifier connections
inapropriate
23/46
SOLUTION
Check AC plug
connection.
Reposition CD with label atop or
clean with a dry and soft cloth.
Possibly exchange connections.
to Place the device on a more stable
stand, rack etc.
Press the Play/Pause-button and
re-program
Check cable and jack quality
10602250_V_1_2.DOC
and AC