Indoor Unit Installation - AUX AM Serie Manual De Usuario E Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Indoor unit installation

Fit the installation plate
1) Fit the installation plate horizontally on structural parts of the wall with spaces
arround the installation plate.
2) If the wall is made of brick, concrete or like, drill five or eight 5mm diameter holes
in the wall. Insert Clip anchor for appropiates mounting screws.
Correct orientation
of Installation Plate
Drill a hole in the w all
1. Determine hole positions according to left and right
side of the installation plate. The hole center is obtained
by measuring the distance as shown in the diagram above.
2. Dirll the piping plate hole with φ65mm hole-core drill.
3. Drill the piping hole at either the right or the left and the
hole should be slightly slanted to the outdoor side.
4. Always take steps to protect the pipe when drilling metal
grid, metal plate or the like.
Connective pipe and drainage installation
1. Run the drain hose sloping downward.
Do not install the drain hose as
illustrated in Fig.7.
2. When connecting extension drain hose,
insulate the connecting part of extension
drain hose with a shield pipe, do not let
the drain hose slack.
INDOOR UNIT INSTALLATION
Do not block water flow by a rise.
35
Wall
Outdoor
Indoor
Do not put the end of
drain hose into water.
Fig.8

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Am2Am3

Tabla de contenido