Machine Usage - Garland Roll & Comb 141 E Manual De Instrucciones

English

6. MACHINE USAGE

Use this machine only for those purposes for which it
has been designed. The usage of this machine for any
other purposes is dangerous and can cause damages
to the user and the machine.
Do not get anywhere near to the comber when the
machine is working.
If you lose your balance or fall, let go of the handle
switch immediately.
Do not solely rely on the security measures of this
machine. Use common sense at all times.
Do not use this machine if you are tired, sick, are
taking medicines, or if under the effect of alcohol or
drugs. Lack of sleep and fatigue can cause accidents
and damages.
Do not use this machine at night, with fog or with
reduced visibility. You must see the working area
clearly at all times.
Limit the usage of the machine to 10 minute stints
and rest for a further 10 to 20 minutes in between
sessions.
Never leave this machine unattended.
Do not allow anybody into the working area whilst the
machine is in use. The working perimeter is minimum
15 metres and this is the danger zone.
Clean and remove obstacles from the working area
that could cause accidents prior to use.
Do not use accessories on this machine except those
recommended by the manufacturer as otherwise the
use of non recommended accessories could cause
severe damages to the user and to the machine.
6.1. HOLDING AND GUIDING THE MACHINE
Whilst working, hold the machine firmly with both
hands on the handles.
Attention! Do not use the machine with just one
hand.
Attention! The machine can jump up or
forwards inadvertently, if the comber hit
something hard that is underground such
as big stones, roots or trunks or if the ground is too
hard or if it is frozen. Always hold the machine firmly
with both hands.
Attention! Always keep an eye as to where the
electric cable is whilst working. Be careful and
ensure that your feet or any object get tangled with
the cable.
6.2. WORKING WITH THE COMBER
Only use this machine to rake atificial grass.
Before starting to use the machine check that the
comber is not in contact with any object and that
they can move freely.
Maintain the cable well away from the moving
elements.
1. Place the machine on the work area with the
comber on the floor.
2. Press the On/Off switch
3. Move the machine slowly over the surface,
pressing lightly
26/80