Home Decorators Collection 56012 Guía De Uso Y Cuidado página 9

Assembly - Hanging the Fan
1
Attaching the fan to the
electrical box
WARNING: To reduce the risk of fire, electric shock,
or other personal injury, mount the fan to an outlet
box or supporting system marked "Acceptable for
fan support of 35 lbs. (15.9kg) or less" and use
the mounting screws provided with the outlet box.
NOTE: The mounting bracket (A) is designed to
slide into place on an outlet box with the outlet box
screws (MM).
□
Pass the 120-Volt supply wires through the center hole
in the slide-on mounting bracket (A).
□
Install the ceiling slide-on mounting bracket (A) on the
outlet box by sliding the slide-on mounting bracket (A)
over the two screws (MM) provided with the outlet box. If
necessary, use leveling washers (not included) between
the slide-on mounting bracket (A) and the outlet box.
Note that the flat side of the slide-on mounting bracket
(A) is toward the outlet box.
□
Securely tighten the two mounting screws (MM).
2
Hanging the fan
WARNING: The hook as shown is only to balance
the fan while attaching wiring. Failure to hang as
shown may result in hook breaking, causing the
fan to fall. The hook must pass from inside to the
outside of the canopy.
WARNING: When hanging the fan on the hook (XX)
it is critical that you use one of the non-slotted
(round) holes in the canopy (C).
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the mounting bracket socket. Ensure that the tab on the
slide-on mounting bracket (A) socket is properly seated in the
groove in the hanger ball.
□
If using close-to-ceiling mounting, hang the fan on the hook
provided by utilizing one of the holes at the outer rim of the
ceiling canopy (C).
XX
9
Please contact 1-800-986-3460 for further assistance.
HOMEDEPOT.COM/HOMEDECORATORS
A
B
C
D
E
A
C