GreenWorks GPW1600 RC Manual Del Operador página 16

CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANdLE
■ Connect the high pressure hose to the pressure washer gun assembly by turning the fitting clockwise.
Ensure the fitting is fully tightened to the pressure washer gun.
NOTE: For easier installation of the hose to the unit or trigger it is suggested to add pressure washer or
dish detergent to the rubber seal at each end of the hose. This will allow for easier installation and a snug
fit.
dETERGENT TANK
■ Insert the male end of the bottle into the female outlet on the trigger handle.
■ While pushing in the bottle firmly, turn clockwise until tabs lock into place to ensure a leak-free
connection.
(See Figure 6-2.)
■ Unscrew the bottle from the assembly and fill with pressure washer detergents/soaps only.
ASSEMBLY
Inlet Coupler
Fig. 6-1
EN - 14
(See Figure 5.)
Collar
High Pressure Hose
Fig. 5
(See Figure 6-1.)
Fig. 6-2