Southland SFTT140 Manual De Operación página 17

Maintenance
• Save all instructions
B
Servicing the Tiller
The following information will help you make the necessary
checks and perform the procedures required to follow the
normal care recommendations made for your tiller unit. If
you prefer, your local authorized dealer can make these
checks and perform the required procedures for you.
WARNING
To prevent accidental starting:
wire
CHANGE BELTS
1. Turn off engine. Engine must be cool completely before
proceeding.
2. Remove spark plug wire and secure from spark plug.
C
Engine Maintenance
ENGINE MAINTENANCE
Refer to the engine manual included in your parts packet
for information on engine maintenance. Your engine
manual provides detailed information and a maintenance
schedule for performing the following tasks:
1. Check oil level before each use or after every 8 hours
of operation.
2. Change oil after first 5-8 hours of operation. Change oil
while engine is warm. Refill with new oil of
recommended grade.
3. Check spark plug yearly or every 100 hours of operation.
4. Service air cleaner.
5. Keep engine and parts clean.
6. Check engine and equipment often for loose nuts and
bolts, keep these items tightened.
CHECK OR FILL ENGINE CRANKCASE
IMPORTANT: Engine is shipped from factory without oil. You
must add engine oil before starting engine.
1. Add oil according to engine manual. Do not overfill.
Use a clean, high quality detergent oil. Do not mix oil
with gasoline. Oil level must be full. Check the oil level
by removing oil fill plug.
2. Always check oil level before starting engine. Refer to
engine manual for capacity and type of oil to use.
Questions? Call Toll Free at 1-800-737-2112
(Continued)
Engine must be turned off
and cool, and spark plug
wire must be removed and
secured from spark plug be-
fore checking and adjusting
engine or equipment.
3. Reduce the belt tension by loosening the cable upper
jam nut.
4. Remove the front and rear belt cover.
• Remove the belt from the engine pulley:
- Loosen the three engine mounting bolts.
- Slide the belt free of the engine pulley.
- Pull the belt down and out of the way.
• Install new belt:
- Loosen the engine mounting bolts.
- Place belt around transmission pulley in groove.
- Place belt onto engine pulley in groove.
- Place backside of belt around idler pulley.
- Tighten engine mounting bolts.
5. Tighten the upper jam nut.
6. Attach spark plug wire.
7. Follow Operating Instructions- start the engine and
operate the clutch lever. Check for proper cable
adjustment. Adjust as required.
WARNING
The tines should not rotate with the engine running, the drag
bar set at transport mode and the drive lever not engaged.
D
Transmission Maintenance
TRANSMISSION MAINTENANCE
1. Check transmission oil level at the beginning of each
season.
2. Remove upper oil plug on side of transmission.
3. Add 90W140 gear oil until oil flows out.
4. Replace plug.
LUBRICATION
Proper lubrication of moving mechanical parts is critical for
proper care and maintenance. Oil the moving parts shown
at 10 hour intervals using a 30 weight oil.
CLEAN TINE AXLE SHAFT
1. Turn off engine. Engine must be cool.
2. Remove spark plug wire and secure from spark plug.
3. Tip the tiller backward. Block the tiller in position so that
it rests on the upper handle and the tines are exposed.
4. Remove all vegetation, string, wire, and other material
that may have accumulated on the axle between the
inside set of tines and the seal cover on the
transmission housing.
5. Tip the tiller back to a level position.
6. Replace spark plug wire.
16
Copyright © 2015 MAT Engine Technologies, LLC