Storing And Caring For The Product - Imetec M3503 Instrucciones Para El Uso

EN
• fit the dust collection system (16) back onto the vacuum cleaner ensuring the position
lock clicks.
CLEANING OR REPLACING THE PREMOTOR HEPA FILTER (16D)
• Press the release button of the dust collection system
system (16) from the appliance [fig. G1].
• Remove the Hepa premotor filter (16D) from the dust collection system (16) [Fig. G3].
• If the Hepa premotor filter (16D) is obstructed by dust, remove the dust taking care not
to damage it.
• If the filter is especially dirty, replace it with a new one.
• fit the HEPA premotor filter (16D) back onto the dust collection system (16) taking care to
push the frame until the top appendix closes the safety interlock (16C).
• fit the dust collection system (16) onto the vacuum cleaner ensuring the position lock
clicks.
CLEANING OR REPLACING THE OUTLET FILTER (16)
• Press the release/locking button of the outlet filter grid (20) to remove the outlet filter
grid (19).
• Extract the outlet filter (18) [fig. G4].
• If the outlet filter (18) is obstructed by dust, remove the dust taking care not to damage it.
• If the filter is especially dirty, replace it with a new one.
• Refit the outlet filter (18) in the appliance [fig. G4].
• fit the outlet filter grid back on (19) and click the coupling/locking button of the outlet
filter grid in position (20).
ATTENTION! Do not use water or any other type of liquid for cleaning the
filters.

STORING AND CARING FOR THE PRODUCT

The flexible suction pipe (5) can be disconnected from the appliance before putting it away.
To this end, press the locking buttons of the flexible suction pipe (6) and disconnect the
flexible suction pipe (5).
The suction pipe (3) with the combined brush (4) may be stored by hooking them to the
appliance with the suitable couplings (12 or 17); the relative pictures in the illustrative guide
are marked with the parking symbol [Fig. F2, F3].
14
MI002394_M3503.indd 14
(9) to extract the dust collection
18/01/2016 12:51:05