Troubleshooting; Disposal - Imetec M3503 Instrucciones Para El Uso

PROBLEM
The appliance does
not go on.
The appliance turns
off during use and
does not turn on
again.
The vacuum cleaner
does not suction
well.
The dust collection
system does not
close correctly.
The vacuum cleaner
produces odours the
first few times it is
used.
The brush remains
too close to the floor
while vacuuming.
The product is packaged in recyclable materials. Dispose of it in compliance with the
environmental protection standards.
Pursuant to Art. 26 of Italian Legislative Decree no. 49 of 14 March 2014 "Implementation
of Directive 2012/19/EU on waste electrical and electronic equipment (WEEE)", the
crossed bin symbol on the appliance or its packaging indicates that the product must
be disposed of separately from other waste at the end of its useful life.
The user must therefore take the appliance to an appropriate recycling centre for
electrical and electronic equipment.
Alternatively, instead of handling the disposal, the appliance can be handed over to the
retailer when a new, equivalent appliance is purchased.
Retailers of electronic products having a sales area of at least 400 m2 can also be handed
electronic products that are to be disposed of measuring less than 25 cm, free of charge and
MI002394_M3503.indd 15

TROUBLESHOOTING

• Ensure the power cord (14) is connected to the power
socket.
• Ensure the ON/Off switch
• The vacuum cleaner is equipped with a protective motor
thermostat that shuts off the appliance in the event of
overheating! (caused by obstructing objects or a clogged
dust collection system).
• In the event of tripping, press the ON/Off switch
unplug the power cord (14) from the power socket and let
the vacuum cleaner cool down completely.
• Remove any dust or the obstructing object before
restarting the appliance.
• Power regulator at a minimum, raise the suction power.
• The dust container (16E) is full: clean the container.
• The filters are clogged: clean or replace the filters.
• The safety interlock (16C) does not allow the dust
collection system to be inserted (16) if the HEPA
premotor filter (16D) is absent.
• Make sure the HEPA premotor filter is present (16D) and
it is fitted correctly.
• These odours are harmless and disappear shortly
afterwards. Ventilate the room.
• Decrease the suction power by acting on the electronic
power regulator (7) or on the manual air flow regulation
device (2).

DISPOSAL

SOLUTION
(8) has been pressed [fig. f1].
EN
,
15
18/01/2016 12:51:05