Bostitch CAP1645-OF Manual De Instrucciones página 16

13 Regulator is damaged
14 Motor overload protection
switch has tripped
15 Tank pressure exceeds
Pressure Switch (H) cut-in
pressure
16 Extension cord is wrong
length or gauge
17 Loose electrical
connections
18 Possible defective motor
19 Paint spray on internal
motor parts
20 Fuse blown, circuit
breaker tripped
21 Worn Belt
22 Restricted air intake filter
Replace.
Motor Overload Protection
Refer to
If motor overload protection trips frequently, contact a
BOSTITCH factory service center
or a BOSTITCH authorized service center.
Motor will start automatically when tank pressure drops
below cut-in pressure of Pressure Switch (H).
Check for proper gauge wire and cord length. Refer to the
Extension Cords paragraph in the Installation section.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center. Do not operate the compressor in
the paint spray area. See flammable vapor warning.
1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for our particular
branch circuit.
2. Check for proper fuse. You should use a time delay fuse.
3. Check for low voltage conditions and/or proper extension cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center.
Clean or replace air intake filter. Do not operate the air
compressor with the filter removed. Refer to the
(J)
paragraph in the Maintenance section.
16
under Features.
Air Filter