How Your Humidifier Works - Essick Air Products E35000 Manual Del Propietário

How Your Humidifier Works

Your new Essick Air® Evaporative
designed to satisfy home humidity
requirements through the principle of
of water in the air.
Once the wick becomes saturated, air
passes through the wick and moisture
into the air. All evaporation occurs in
humidifier so any residue remains in
This natural process of evaporation
white dust like some other humidifiers.
When Outdoor Recommended
Indoor Relative
:
Temperature is
Humidity (RH) is
F C
-10° -24° 20%
2° -18° 25%
10° -12° 30%
20°* -6°* 35%
* or higher
WARNING:
For your own safety, do not use humidifier if any parts are damaged or missing
Set Up and Location
1) Unpack humidifier from carton and remove all packaging material, wick, etc. from box.
2) Place humidifier on a flat level surface. Position the humidifier where the most humidity is
needed or where the most air will be circulated throughout the house such as near a cold
air return. If the unit is positioned close to a window, condensation may form on the
window pane. If this occurs the unit should be repositioned in another location.
CAUTION: Do NOT position the unit directly in front of a hot air duct or radiator.
Do NOT place on soft carpet. We suggest placing the unit on a table or on a
bookshelf.
NOTE:
Due to release of cool, moist air from humidifier, it is best to direct air away from
thermostat and hot air registers, and to position humidifier next to an inside wall. Unit
should not be placed where cold air from outside walls or warm air from a hot air register
blows directly on it.
3) Place the humidifier at least 4 inches from the wall.
Air is drawn
in through
the vents
in the back
Humidified air is
expelled out the
front louvers
IMPORTANT: Water damage may
result if condensation starts to form
on windows or walls. Humidity SET
point should be lowered until
condensation no longer forms. We
recommend room humidity levels do
not exceed 50%.
4
humidifier is
evaporation
is drawn in,
is absorbed
the
the wick.
creates no