7
Attention: to restore the aperture of the blades to maximum (standard), carry out the steps for
blades' lock/unlock described as follows.
Manual activation of the security lock/unlock of the blades:
1.
To activate the security lock of the blades, keep the trigger pulled until the shears emit an
audible tone, followed by other two repeated audible tones (1 beep, 1 beep-beep). With
this operation, the blades close. By pulling the trigger, the blades don't move.
2.
To deactivate the security lock of the blades, quickly pull the trigger twice, repeatedly. The
shears emit and audible tone (1 beep) and the blades open to maximum aperture. Now the
blades close whenever the trigger is pulled.
Attention: every time that the shears are manually set into security lock mode, all the settings
are restored to standard. Therefore, once the security lock is deactivated, the shears will be in
progressive cutting mode with maximum aperture of the blades.
General instructions
Normally, the cuttings are even and smooth causing no damage to the plants. If an abnormality
occurs, simply release the trigger and the blade will open in the maximum position to avoid
personal injury or property damage. Do not use the device on rainy days. Before using, please
check if the blade is sharp. If the blade is blunt, be sure to sharpen the blade to obtain optimal
performance and avoid damages to the shears. Always close the blades before switching the
shears off, in order to avoid any damages to things or people.
130
Art. 311
Pruning shears Vulcano E-30 TP
Usage
Art. 311
Pruning shears Vulcano E-30 TP
Usage
Charging the battery
Do not expose the battery to extreme conditions such as high temperatures or shocks.
Otherwise, personal injury will result from leakage of the electrolytic solution.
Before charging, check that the battery surface is clean and dry.
•
At the time of delivery, the battery of this product is not fully charged. Therefore, the
•
user must fully charge it before using it for the first time.
•
Charge the battery when the power indicator light is lit.
•
Do not charge the battery for a long time, and avoid using all the power in the battery, other-
wise the battery will be damaged.
•
If the battery life of the fully charged battery is significantly shorter, it proves that the battery
has been used up and must be replaced. Users can only use original batteries. In order to
obtain a new battery, users can contact a local reseller or Stocker srl.
•
Always keep in mind the applicable safety instructions, environmental regulations and environ-
mental information.
•
Place the charger in a room between 10 °C and 22 °C at room temperature to prevent
moisture ingress.
•
Check if the switch is in the off position.
•
Connect the charger's adapter to the appropriate connector of the battery pack.
•
Make sure the power supply matches the rating on the charger and adapter.
•
When the red light on the charger is on, it indicates that the battery is charging, and the green
light indicates that charging is complete. The average charging time is 2,5 hours.
•
When charging is complete, unplug the connector from the power source and disconnect the
connector from the battery.
•
Please ensure that the battery is charged at least once every six months when the battery is
not in use for a long time.
For further information about the product, please contact info@stockergarden.com
Sign up to our newsletter and keep up to date with our latest news www.stockergarden.com/newsletter
7
131