Maxon T-340 Instrucciones página 15

6. Hold the RH mounting bracket
against the corner post. Then, drill
using two holes in bracket as a guide
(FIG. 15-1). Repeat Step 5 for LH
mounting bracket.
7. Fasten each bracket to the pickup
bed with the hex head bolts (Kit item).
Then, fasten the lock washers (Kit
item) and hex nuts (Kit item) to the
back plate (Kit item) under the pickup
bed (FIG. 15-1).
8. Adjust Liftgate so platform is level
from front to back. Then, tighten bolts
securing the main frame mounting
brackets to the RH and LH mounting
brackets (FIG. 15-2).
1. Locate the existing 3/8" hole in the RH
mounting bracket (FIG. 15-2).
2. Mark and drill a 3/8" hole in the in-
ner side of the pickup bed using the
RH mounting bracket hole as a guide
(FIG. 15-2).
3. Fasten the RH mounting bracket to
the inner side of pickup bed with the
lock washer (Kit item) and nut (Kit
item) on the bracket side. Then, fas-
ten the hex head bolt (Kit item) and
15-2).
4. Repeat Steps 1 through 3 for the LH
mounting bracket.
5. Install taillight lenses.
LIFT CORPORATION Sht. 15 of 58 DSG#
INSTALL LIFTGATE - Continued
ADD ADDITIONAL SUPPORT
(FIG.
3/8" X 1" BOLT
(2 PLACES)
DRILLED 3/8"
HOLE
(2 PLACES)
BACK
PLATE
3/8" LOCK
WASHER
(2 PLACES)
HEX NUT
(2 PLACES)
FASTENING BRACKET AND BACK PLATE TO
TRUCK BED (RH SIDE SHOWN)
INNER SIDE OF
PICKUP BED
3/8" HOLE
3/8" LOCK
WASHER
3/8" NUT
FASTENING BRACKET TO PICKUP BED
(RIGHT SIDE SHOWN)
M-15-25
Rev. E Date: 08/13/19
FIG. 15-1
3/8" X 1" BOLT
FIG. 15-2
TAILLIGHT
LENS
3/8" FLAT
WASHER