Installation Instructions; Unpacking Your Refrigerator; Leveling Your Refrigerator; Proper Air Circulation - Haier HC27SG42RB Manual Del Usuario

INSTALLATION INSTRUCTIONS

UNPACKING YOUR REFRIGERATOR

1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the refrigerator accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials
before powering on the refrigerator.
WARNING
Do not puncture refrigerant tubing. Flammable refrigerant used. Handle
with care when moving refrigerator to avoid either damaging the
refrigerant tubing or increasing the risk of a leak.

LEVELING YOUR REFRIGERATOR

• Your refrigerator has two leveling legs which are located in the front
bottom corners of your refrigerator. After properly placing your
refrigerator in its final position, you can level your refrigerator.
• Leveling legs can be adjusted by turning them counterclockwise to raise
your refrigerator or by turning them clockwise to lower your refrigerator.
The refrigerator door will close easier when the leveling legs are
extended.

PROPER AIR CIRCULATION

• To ensure your refrigerator works at the maximum efficiency it was
designed for, you should install it in a location where there is proper air
circulation, plumbing and electrical connections.
• The following are recommended clearances around the refrigerator:
Sides . . . . . . . . . 4"
Top . . . . . . . . . . . 4"
Back . . . . . . . . . . 4

DOOR ALIGNMENT

1. Remove the top hinge cover by using a flathead
screwdriver. Place the head under the front edge of
the cap and gently lift.
2. Loosen the top hinge screws using a Phillips head
screw driver.
3. Adjust the door or put a spacer in between and
tighten the screws.
4. Replace the top hinge cover by aligning the rear of
the cover with the rear of the hinge. Press firmly on the front of the cover
until it snaps in place.
49-60777
EXPLOSION HAZARD
7