Transportation And Storage; Cleaning And Maintenance - MSW HPF 2000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 17
1.
Hot air outlet nozzle / location for attaching accessories.
2.
Trigger with temperature and air flow control.
3.
Power cable
4.
Heat gun stand.
Device operation
1.
Set switch to "0" and insert plug into an electricity socket.
2.
Then turn on the device by setting the switch to 1 or 2. See table below for information about the
temperature and air flow intensity for given settings of the switch (during initial use, the heat gun may
emit a small quantity of smoke. After a certain time this will cease). To set the air temperature use
The switch marked with the number 2 on the picture – setting I or II.
Table showing temperatures and air flow speeds for various settings
Model
Parameter
Temperature [°C]
Settings I
350
Settings II
550
Attachment of additional nozzles
The set includes additional nozzles, which can be used for specific jobs. To attach additional nozzles, slide it
over the heat gun outlet nozzle. Attention! If changing / attaching additional nozzles make sure the device is
cold and then disconnect it from the power source.
Attaching accessories
Cone nozzle
Fish tail nozzle
Glass protection nozzle
A set of scrapers is also included. Mount them onto the handle (also included) between two nuts on the
stem of the handle.
ATTENTION! After each use, the heat gun must be placed on the stand for cooling. Do not leave the hot
device near flammable materials.
IX. TRANSPORTATION AND STORAGE
During transport, the machine should be protected from shaking, crashing and turning upside down. Store it
in a properly ventilated place with dry air and without any corrosive gas.
X. CLEANING AND MAINTENANCE
Disconnect the machine from the electricity when cleaning it.
Use cleaner without corrosive substances to clean surface.
10
HPF 2000
Air flow [l/min]
300
500
Rev. 05.05.2017
After cleaning, all parts should be able to dry before the machine is to be reused
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
Never spray the device with water jets.
XI. CHECK REGULARLY THE DEVICE
Check regularly the machine for signs of damage. If the machine is damaged, please stop using it immediately
and contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare following information:
Invoice number and serial number (the latter is to be found on the technical plate on the machine).
If relevant, take a picture of the damaged, broken or defective part.
It will be easier for your customer service clerk to determine the source of the problem if you give
a detailed and precise description of the matter. Avoid formulations like „the device doesn't ́ t heat up",
which may mean that it doesn't ́ t heat enough or even not at all. The more detailed your information,
the better customer service will be able to solve your problem rapidly and efficiently!
CAUTION: Never open the machine without the authorization of your customer service. This can lead
to a loss of warranty!
Rev. 05.05.2017
11

Publicidad

Tabla de contenido
loading

Tabla de contenido