Manual Defrost; Cleaning, Care & Maintenance - Polar Refrigeration GD881 Manual De Instrucciones

Vitrina refrigerada de pasteleria
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 27
UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the
appliance in position.
Operation
Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Control Panel
Set the Operating Temperature
1. Press the SET button. The display will flash.
2. Press the
or
required temperature.
3. Press the SET button to store the temperature.
4
GD881_ML_A5_v5_20181105.indb 4

Manual Defrost

Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
Cleaning, Care &
Maintenance
Cleaning the Condenser
buttons to display the
Switch off and disconnect from the power
supply before cleaning.
Clean the interior of the appliance as often as
possible.
Do not use abrasive cleaning agents. These
can leave harmful residues.
Clean the door seal with warm soapy water.
Always wipe dry after cleaning.
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
A POLAR agent or qualified technician must
carry out repairs if required.
The condenser is part of the refrigeration
system. The condenser requires monthly
cleaning.
Always disconnect power supply before
carrying out Routine Maintenance.
Failure to clean the condenser will reduce the
performance and life of your Polar unit and
may invalidate your warranty.
This model has a removable filter which can be
cleaned with a vacuum cleaner.
2018/11/5 11:23

Publicidad

Tabla de contenido
loading

Tabla de contenido