Unpacking Instructions - Fanimation KINDRED LP8543LGR Manual Del Usuario

This manual is designed to make it as easy as possible for you to assemble,
install, operate and maintain your ceiling fan
Tools Needed for Assembly
(Not included)
ne hillips head screwdriver
One stepladder
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 11). If you
feel you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check
mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should
you be interrupted.
Do not install or use fan if any part is damaged or missing. This product is designed to use only those parts
supplied with this product and/or any accessories designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not designated for use with this productby Fanimation could
result in personal injury or property damage.
1. Check to see that you have received the following parts:
NOTE: If you are uncertain of part description, refer to exploded view illustration.
Hanger Bracket
Assembly (1)
Downrod/Hanger Ball
Assembly (1)
– Downrod (1)
– Hanger Ball (1)
– Clevis Pin (1)
– Hairpin Clip (1)
– Set Screw (1)
– Pin (1)
Canopy Screw
Cover Assembly (1)
Hardware Bags
Wire Connectors (4)
One wire stripper
One lade
screwdriver
WARNING

Unpacking Instructions

Motor Coupling
Cover Assembly (1)
Ceiling Canopy (1)
Motor Assembly (1)
Light Plate Assembly (1)
1/4˝ -20 Pan Head
Screws with lock washer (22)
iring outlet o and o connectors
re uired y the local code
conductor
nstalled
p to
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are
missing contact your local retailer.
Light Kit/Glass Assembly (1)
Blade Support Set (1)
Hand-held Remote (1)
Wall Plate (1)
Screws (2)
Receiver (1)
Batteries (2)
Wire Connectors (9)
4
Materials
he ini u
wire with ground of the following si e:
ire ength ire i e
ft
ft
Blade Holder Set (1)
Blade Plate Set (1)
3/16˝ -24
Serrated Head Screws (37)
ust e of type
wire would e a
Blade Set (1)