Switch Housing Assembly; Testing Your Fan - Craftmade Sloan Guia De Instalacion

9. Switch Housing Assembly.

Remove 1 screw from motor plate (on underside
of motor) and partially loosen the other 2
screws. Align slotted holes in middle of switch
housing plate with loosened screws in motor
plate, allowing female plug from motor housing
to come through hole in middle of switch
housing plate. Twist switch housing plate to lock.
Re-insert screw that was just removed and
tighten all 3 screws securely.
Remove all 3 screws on outer edge of switch
housing plate. Connect male plug from fan to
female plug from switch housing, matching up
the colors on the male plug with the colors on
the female plug for correct fit. Be sure that the
plugs connect completely.
Now, lift switch housing to switch housing plate,
aligning slotted holes in switch housing with
holes in switch housing plate. (Note: The gap on
the edge of the switch housing cap must align
with the reverse switch on the switch housing
for the proper fit.) Re-insert screws that were
previously removed and secure all 3 screws with
a Phillips screwdriver.

10. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with pull chain.
(diagram 1) Start at the OFF position (no blade
movement). First pull will set the fan to HI. Second pull
will set the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again set the fan to the OFF
setting. If fan does not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT for
fan to function. If the reverse switch is set in the
middle position (diagram 4), fan will not operate.
Attach pull chain extension supplied or custom pull
chain extension (sold separately) to the end of the
pull chain.
switch
housing
plate
switch
housing
plate
switch
housing
diagram 1
diagram 2
page 7
motor
housing
male plug
female plug
reverse
switch
pull chain
extension
diagram 3 diagram 4
motor
housing