Winch Installation - Trakker KT2000 Manual Para El Propietario

Winch Installation

Correct installation of your Winch is required
for proper operation.
Mounting kits are available for most popular
ATV, UTV and trailer applications. Call 800-
533-7372 or go to www.trakkerwinch.com.
Detailed mounting instructions are provided
with each mounting kit. Read and follow
directions carefully to ensure proper Winch
alignment and trouble free operation.
This Winch MUST be mounted with the wire
rope in the under-wind direction (Figure 8)
Figure 8
WARNING
Improper mounting could damage your Winch
and void your warranty.
Step 1. Install mounting kit or structural
support for Winch (not included) to ATV or
other vehicle or surface.
Step 2. Mount the Winch to the mounting kit
base plate or to the mount that you have
designed. Mount must be a flat surface
capable of handling winch loads. The
mounting bolts supplied are the correct
length for use with a 1/4" (5mm) thick
mounting plate. If mounting plate is thicker
than 1/4" (5mm) adjust bolt length accordingly.
Use only metric M8 diameter, grade 8.8 bolts.
WARNING
DO NOT SUBSTITUTE ANY STRENGTH
GRADE BOLT AND NUTS LESS THAN ISO
GRADE 8.8.
Step 3. Before making electrical connections
disconnect the vehicle battery leads.
WARNING
Batteries contain gases, which are flammable
and explosive. WEAR EYE PROTECTION
DURING INSTALLATION AND REMOVE ALL
METAL JEWELRY. Do not lean over battery
while making connections.
WARNING
Ensure that the wiring harness does not
interfere or come in contact with any hot
or moving engine, suspension, steering,
braking or exhaust parts.
Step 4. Follow electrical connection diagram
(Figure 9) paying close attention to wire color
connections from the battery, to the hand
held switch, to the winch.
Step 5. Reconnect the battery.
Step 6. Pull and turn the freespool clutch
knob to the disengage position (See Figure 7).
Pull several feet of wire rope off the drum.
Return the freespool clutch dial back to
engaged position. Activate the Winch cable in
and out by momentarily pressing the hand
held switch to check drum rotation direction.
If the drum rotates in the wrong direction,
recheck your wiring. If not working in the
correct position you may have reversed the
wires on the motor. Then check the switch
wires to make sure they are connected
properly.
5