Craftsman 247.288853 Manual Del Operador página 23

8. Remove the bow-tie cotter pin securing the deck stabilizer rod to the deck.
Slide the deck lift rod from the mounting bracket on the deck as shown in
Figure 20.
9. Carefully remove the PTO cable from the rear of the cutting deck by
removing the bow-tie cotter pin which secures it. Remove the spring from
the deck idler bracket. See Figure 20.
10. Gently slide the cutting deck (from the left side) out from underneath the
tractor.
Tires
WARNING
Never exceed the maximum inflation pressure shown on the sidewall of
tire.
SERVICE AND MAINTENANCE
Figure 20
Figure 21
The recommended operating tire pressure is:
• Approximately 10 psi for the rear tires
• Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire pressure could
cause the cutting deck to mow unevenly.
Battery
California Proposition 65 WARNING! Battery posts, terminals, and related
accessories contain lead and lead compounds, chemicals known to the State of
California to cause cancer and reproductive harm. Wash hands after handling.
If removing the battery, disconnect the NEGATIVE (Black) wire from its
terminal first, followed by the POSITIVE (Red) wire. When re-installing
the battery, always connect the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
Jump Starting
Never jump start a damaged or frozen battery. Be certain the vehicles
do not touch, and ignitions are off. Do not allow cable clamps to
touch.
1. Connect positive (+) cable to positive post (+) of your tractor's discharged
battery.
2. Connect the other end of the cable to the (positive +) post of the jumper
battery.
3. Connect the second cable (negative –) to the other post of the jumper
battery.
4. Connect the other end of the negative cable to the engine block of the
tractor, away from the battery. Attach to an unpainted part to assure a good
connection.
If the jumper battery is installed on a vehicle (i.e. car, truck), do NOT start
the vehicle's engine when jump starting your tractor.
5. Start the tractor (as instructed earlier in this section of this manual).
6. Set the tractor's parking brake before removing the jumper cables, in reverse
order of connection.
Charging
Batteries give off an explosive gas while charging. Charge the battery in
a well ventilated area and keep away from an open flame or pilot light
as on a water heater, space heater, furnace, clothes dryer or other gas
appliances.
When charging your tractor's battery, use only a charger designed for 12V lead-
acid batteries. Read your battery charger's Owner's Manual prior to charging
your tractor's battery. Always follow its instructions and heed its warnings.
23
CAUTION
WARNING
WARNING
WARNING
CAUTION